Network and Low-Voltage Wiring in Wesley Chapel, FL
Wired Jacks and Access Point Cable for Finished Homes|Licensed & Insured, EC13011268
Kennedy Electric runs Cat6 network cable through Wesley Chapel homes that are already finished and lived in. Where the attic gives the cable a way across, it drops behind a wall to a new jack or ends at a ceiling plate for an access point, with little of the drywall along its path opened.
Mention any room where the Wi-Fi drops out.
Call (352) 251-2795, Monday through Friday, 8 a.m. to 4 p.m., or send a request online. Calls after hours are returned the next business day.
At a glance
Wesley Chapel's Broadband Lines and the Low-Voltage Exemption
Close to nine in ten Wesley Chapel households, roughly 22,400 of 25,200 in census estimates, subscribe to broadband by cable, fiber optic, or DSL, which arrives on a physical line. Where that line comes through the wall fixes where the modem and router sit, and that corner is the starting end of every new run.
A receptacle added in that corner is electrical work, and Pasco County's permit covers it. The cable leaving it is another case: cable TV and internet wiring inside a house is on the county's list of residential low-voltage jobs that need no building permit.
How it runs
The Household's Share of a Network Wiring Job
-
1
Clear the way to the attic hatch
Most runs cross the attic, so the electrician needs a clear way up. Where the hatch sits in a garage ceiling or a closet, move the car, the boxes, or the hanging clothes below it before the visit.
-
2
Choose the hardware for the router end
Every new cable comes back to the router, and a router alone rarely has a port for each one. A network switch adds ports. If the access points take their power over the cable, that switch has to supply it, or each access point needs a small injector at that end. That holds for prewired ceilings too: one builder's standard package in a Wesley Chapel community has included prewires for access points in the house and out on the lanai, and if the access points later hung on them take power over the cable, that power comes from the same router end. Equipment you already own or prefer is welcome.
-
3
Name the walls to leave alone
Point out any wall that shouldn't be opened, such as one with tile, a built-in, or a mounted TV you'd rather not take down. The cable can usually reach that room by another wall or from the ceiling side.
-
4
Try every jack with a device
Once the router end is connected, plug a laptop, the TV, or a console into each new jack and confirm it connects. If one won't, let our office know which room it's in.
What we cover
Network Cable Where a Wesley Chapel House Needs It
Each new cable ends in one of these places, starting at the equipment, and each place asks something different of the route.
Room for network equipment where the line comes in
The modem often sits on a garage wall or inside a closet. Once new runs come back to it, that spot holds more than a modem: the router, a network switch, and sometimes a small patch panel where each room's cable is terminated. That corner then needs wall space and a shelf, with power close enough for every box on it.
A home-office desk upstairs or down
A loft or an upstairs bedroom sits right under the attic, so its cable drops straight into the wall from above. A downstairs room under a second floor is the harder reach, because the floor between blocks the way down. Its cable can come through a closet stacked above it, or another hidden path the walk-through turns up. In a single-story house, nearly every room is reached from the attic.
A wired jack on the TV wall
A smart TV, a streaming box, or a game console stays in one place and can move a lot of data in an evening. On a jack, it stops competing with phones and laptops for the router's wireless signal, which leaves more of that signal for the devices people carry from room to room.
Access points for ceilings and the lanai
These runs are often the last stop on the route. A ceiling plate in a single-story house is one of the simplest of them, straight down from the attic, and an upstairs ceiling in a two-story house is reached the same way. Out on the lanai, the access point mounts under a solid roof where the lanai has one, and its maker's outdoor or damp-location rating decides which model belongs there.
Pricing
The Bill for Network Cable Behind Closed Walls
The count of jacks and ceiling plates on your list, and each one's distance from the router, set the price.
Custom homes and large or multi-phase projects are estimated as soon as we can, or on the timeline your project sets.
Repair and troubleshooting visits are billed by the hour from arrival: $100 residential, $150 commercial, one-hour minimum, then half-hour increments, plus materials. No trip charge and no service fee. No hidden fees: the 3.5% surcharge on card and ACH payments is listed in our terms.
We don't do upfront pricing. No job has a standard price with us: each one is tailored to the property and the work you've asked for, and priced once we've seen it.
We offer free estimates on installs, upgrades, and replacements in our service area. Estimates aren't free when the job needs troubleshooting or testing to price, falls after hours or outside our service area, needs several meetings to gather information, or is new construction or a custom remodel with multi-party walk-throughs. For most jobs, estimates arrive by email by the end of the next business day, and quotes are good for 30 days.
Our warranty
05If something we installed fails because of our workmanship within 30 days of completion, we waive the hourly labor to put it right. Materials Kennedy Electric purchases for your job carry the manufacturer's one-year warranty. To replace defective materials we supplied, or materials damaged by storm, flood, fire, or other acts of God, we charge a reduced warranty labor rate of $50 an hour residential and $75 an hour commercial. The warranty does not cover materials not purchased by Kennedy Electric, work performed by the customer, or materials the customer purchased or damaged. Our warranty terms are printed on the estimate, the invoice, and the receipt, and the product boxes stay with you so you can register each product with its manufacturer.
Our Wesley Chapel house has cable TV outlets in most rooms. Can they carry the network instead of new Cat6?
The TV wall already has a coax connector. Can the new network jack share its plate?
Can our mesh Wi-Fi units be linked by cable instead of wirelessly?
How many access points does a two-story Wesley Chapel house need?
Can a network cable reach a detached garage or a workshop?
Reviews
Network Wiring Jobs Under the Microscope
Straight from Google, in our customers' own words.
Request service
Connect the Far Rooms of Your Wesley Chapel House
Note the rooms and ceilings that should get a cable, and which floor each one is on. Our office will reach you during business hours.