HomeService AreasWeeki WacheeWell Pump and Septic Electrical
Well Pump and Septic Electrical in Weeki Wachee, FL
Circuits for Aerobic Units, Pump Tanks, and Well Pumps|Licensed & Insured, EC13011268
Tell us whether the job is a septic system, a well pump, or both.
When a drainfield fails within the Weeki Wachee Springs priority focus area, the repair permit now requires a nitrogen-reducing septic system, and the owner has to choose one with a failed system in the yard. The state accepts several types, and it doesn't ask the same thing of your electrical panel. One may drain by gravity and use no power. Another needs an aerator circuit, an alarm, and a maintenance contract for as long as it's in the ground.
Call (352) 251-2795, Monday through Friday, 8 a.m. to 4 p.m., or send a request online. Calls after hours are returned the next business day.
Accepted Systems
Power Needs of the Accepted Nitrogen-Reducing Systems
The priority focus area is mapped parcel by parcel, and parts of North Weeki Wachee fall inside it. The Florida Department of Health in Hernando County confirms a parcel's status. For a parcel that's inside, the state accepts in-ground biofilters, nitrogen-reducing aerobic treatment units, and performance-based treatment systems.
Our part in any of them is the electrical side: a circuit to the pump or aerator, its shut-off, and the alarm wiring. The system itself is the septic contractor's work. We run well pump circuits too.
An in-ground biofilter with no liner
The drainfield is built over a layer of sand and a layer of wood-based material that strips nitrogen as the wastewater drains through. Any approved way of spreading the wastewater is allowed, so on a lot where gravity can do it, there may be nothing for an electrician to wire. If the site needs a pump to lift or dose the wastewater, the system has a pump tank. This type needs no maintenance contract and no operating permit.
An in-ground biofilter with a liner
With an impermeable liner under those layers, the design must come from a professional engineer, and the drainfield must be low-pressure dosed unless the engineer chooses another method. Dosing under pressure takes a pump, and a pump brings a pump tank, a pump circuit, and a high-water alarm.
An aerobic treatment unit
The unit treats wastewater by moving air through it, so it can't work without power. It needs a circuit for the aerator and an alarm that reports a failure, and it's approved only with a maintenance contract and an operating permit from the county health department.
A performance-based treatment system
These systems are engineer-designed and vary widely. Some include an aerobic unit along with other components. The engineer's plans show what gets power, and the circuits follow the drawings. A maintenance contract and an operating permit come with this type as well.
Pump tanks
Where the Conduit Leaves a Pump Tank
Any system that doses with a pump has a pump tank, and the state's septic rules reach into how that tank is wired. The electrical conduit has to leave the dosing chamber by one of three routes: through the tank outlet with watertight fittings, through the wall of a riser above the wet-season water table with a soil-tight seal, or through an access port the manufacturer put in the lid, sealed after the conduit is in.
A hole cut wherever the trench happens to arrive isn't on that list. The run from your panel is laid out back from the point where the conduit exits the tank.
From the Septic Permit
What the Septic Permit Tells the Electrician
1. The system named on the permit
The type, and for an aerobic unit the make and model, set the circuit: its voltage, its breaker size, and whether the manufacturer supplies a control panel.
2. Where the tank and any control panel will sit
That fixes the length of the run from your panel and where the trench crosses the yard. The trench stays off the drainfield.
3. Room in the house panel
A pump or aerator circuit needs breaker space. Where the panel is full, a subpanel is one way to make room.
Aerobic units
Keeping an Aerobic Unit Powered
The maintenance contract is between the owner and a maintenance company approved by the state. The first contract runs at least two years; renewals run at least a year each for the life of the system, and the unit is inspected at least twice a year.
So an alarm on an aerobic unit has two possible owners. A dead circuit or a damaged cable between the house and the unit is electrical work. A unit that has power and has still failed belongs to the maintenance company under that contract.
We don't install backup power for well pumps or medical equipment, nor do we install standby generators.
Is Hernando County still helping pay for these systems?
Can the aerator be set to a timer or switched off while we're away?
How quickly does the maintenance company have to come when the unit fails?
Billing
Billing a Septic or Well Circuit Job
We don't do upfront pricing. No job has a standard price with us: each one is tailored to the property and the work you've asked for, and priced once we've seen it.
We offer free estimates on installs, upgrades, and replacements in our service area. Estimates aren't free when the job needs troubleshooting or testing to price, falls after hours or outside our service area, needs several meetings to gather information, or is new construction or a custom remodel with multi-party walk-throughs. For most jobs, estimates arrive by email by the end of the next business day, and quotes are good for 30 days.
Custom homes and large or multi-phase projects are estimated as soon as we can, or on the timeline your project sets.
Repair and troubleshooting visits are billed by the hour from arrival: $100 residential, $150 commercial, one-hour minimum, then half-hour increments, plus materials. No trip charge and no service fee. No hidden fees: the 3.5% surcharge on card and ACH payments is listed in our terms.
Warranty on circuits and alarm wiring
04If something we installed fails because of our workmanship within 30 days of completion, we waive the hourly labor to put it right. Materials Kennedy Electric purchases for your job carry the manufacturer's one-year warranty. To replace defective materials we supplied, or materials damaged by storm, flood, fire, or other acts of God, we charge a reduced warranty labor rate of $50 an hour residential and $75 an hour commercial. The warranty does not cover materials not purchased by Kennedy Electric, work performed by the customer, or materials the customer purchased or damaged. Our warranty terms are printed on the estimate, the invoice, and the receipt, and the product boxes stay with you so you can register each product with its manufacturer.
Reviews
Ratings and Comments From Our Google Listing
Straight from Google, in our customers' own words.
Contact us
Send the Septic Permit Details for Your Weeki Wachee Home
Send the address, the system type on your septic permit or proposal, and where the tank will sit. Our office staff will reply during business hours.